LG VS
Vibration Sensor Error
Medium severityVerified Diagnostic Guide
SeverityMedium
What Your Machine Is Actually Telling You
VS means the vibration sensing system (MEMS accelerometer or vibration sensor) is sending out-of-range or no data. LG uses this sensor for its TrueBalance™ technology — dynamically adjusting spin speed to minimize vibration.
Common causes:
1. Sensor hardware failure (30%) — chip failed.
2. Wiring to sensor (25%) — connector loose.
3. Sensor mount loose (15%) — not firmly attached.
4. Main board (15%) — sensor input circuit.
5. Software glitch (15%) — temporary lock-up.
Common causes:
1. Sensor hardware failure (30%) — chip failed.
2. Wiring to sensor (25%) — connector loose.
3. Sensor mount loose (15%) — not firmly attached.
4. Main board (15%) — sensor input circuit.
5. Software glitch (15%) — temporary lock-up.
What You're Probably Seeing Right Now
- VS during spin ramp-up.
- Machine won't reach full spin speed.
- VS appeared suddenly.
- VS is intermittent.
DIY Fix — From Easiest to Hardest
1
Power Reset (5 minutes — Fixes 15%)
1. Unplug for 10 minutes.
2. Test with Rinse+Spin.
3. If VS clears: temporary glitch.
2. Test with Rinse+Spin.
3. If VS clears: temporary glitch.
2
Level the Machine (5 minutes)
Abnormal vibration from unlevel machine:
1. Spirit level on top.
2. Adjust all four feet.
3. No rocking.
1. Spirit level on top.
2. Adjust all four feet.
3. No rocking.
3
Check Sensor Connections (10 minutes)
1. Unplug, remove top panel.
2. Find vibration sensor (small board on tub/frame).
3. Reconnect connector firmly.
4. Check for corrosion.
5. Ensure sensor is firmly mounted.
2. Find vibration sensor (small board on tub/frame).
3. Reconnect connector firmly.
4. Check for corrosion.
5. Ensure sensor is firmly mounted.
4
Replace Sensor (15 minutes)
If sensor confirmed faulty:
1. Disconnect and remove.
2. Install new sensor ($20-50).
3. Secure mounting.
4. Reconnect and test.
1. Disconnect and remove.
2. Install new sensor ($20-50).
3. Secure mounting.
4. Reconnect and test.
When to Call a Pro
- •Vibration sensor — $80-$200 installed.
- •Main board — $150-$400.
What It'll Cost You
Swipe left to see full table
Frequently Asked Questions: Error VS
What does error code VS mean on a LG washing machine?
Vibration sensor malfunction.
What usually causes the LG VS error?
The primary cause is: Sensor failed or connection loose.. It may also be caused by temporary sensor misreadings or wiring connection issues.
How do I reset and clear error VS?
Restart machine. Ensure machine is perfectly level on the floor. If the error persists, unplug the washer from electrical power for 10 minutes to perform a complete logic board reset.
Is it safe to continue using the machine with error VS?
This code has a Medium severity level. While the machine might run, resolving the issue early prevents long-term wear on internal parts.