Maytag dE
Door/Lid Error
Medium severityVerified Diagnostic Guide
SeverityMedium
What Your Machine Is Actually Telling You
dE means the door lock didn't confirm engagement. The CCU requires door lock verification before starting any cycle.
Common causes:
1. Door not fully closed (25%).
2. Clothes in gasket (20%).
3. Lock mechanism worn (20%).
4. Door hinge sagging (10%).
5. Wiring (10%).
6. CCU relay (10%).
7. Strike plate (5%).
Common causes:
1. Door not fully closed (25%).
2. Clothes in gasket (20%).
3. Lock mechanism worn (20%).
4. Door hinge sagging (10%).
5. Wiring (10%).
6. CCU relay (10%).
7. Strike plate (5%).
What You're Probably Seeing Right Now
- dE on pressing Start.
- Door looks closed.
- Lock clicks but doesn't hold.
- dE after power outage.
DIY Fix — From Easiest to Hardest
1
Close Door Properly (30 seconds — Fixes 45%)
1. Open fully.
2. Clear trapped items from seal.
3. Close firmly at lock corner.
4. Listen for click.
2. Clear trapped items from seal.
3. Close firmly at lock corner.
4. Listen for click.
2
Power Reset (5 minutes)
1. Unplug 5 minutes.
2. Try again.
2. Try again.
3
Check Alignment (3 minutes)
1. Watch strike enter lock.
2. Tighten hinge screws.
3. Replace strike if bent ($15-25).
2. Tighten hinge screws.
3. Replace strike if bent ($15-25).
4
Replace Lock (15 minutes)
1. Test PTC: 800-1500Ω.
2. If failed: replace ($25-50).
3. Peel back gasket, remove screws.
4. Swap and test.
2. If failed: replace ($25-50).
3. Peel back gasket, remove screws.
4. Swap and test.
When to Call a Pro
- •Lock assembly — $80-$200.
- •Door hinge — $80-$180.
- •CCU — $200-$500.
What It'll Cost You
Swipe left to see full table
Frequently Asked Questions: Error dE
What does error code dE mean on a Maytag washing machine?
Lid not locking.
What usually causes the Maytag dE error?
The primary cause is: Lid lock/switch failure.. It may also be caused by temporary sensor misreadings or wiring connection issues.
How do I reset and clear error dE?
Replace lid lock assembly. If the error persists, unplug the washer from electrical power for 10 minutes to perform a complete logic board reset.
Is it safe to continue using the machine with error dE?
This code has a Medium severity level. While the machine might run, resolving the issue early prevents long-term wear on internal parts.